B72/100 PRESSBRAKE DEMONSTRATION ONE OF OUR POTENTIAL CUSTOMERS REQUESTED A CLIP DEMONSTRATING HOW OUR LINKAGE SYSTEM RESPONDS TO UNEVEN LOAD. PRESS BRAKE IS SHOWN BOTTOMING WITH 30 TONS OF PRESSURE AGAINST STEEL BLOCK PLACED TO ONE SIDE. 2min, 46sec. RATED D (Demonstrative)
The B72/100is a simple, no nonsense press brake that has a powerful hyrdo/mechanical ram system that is capable of up to 100 tons! Brake is rated for bending five foot of 1/4" mild steel with a 3" die opening. Two stage hydraulic system allows for reasonable fast bending speeds with smaller single phase motors. Standard machine features an easy hydraulic stroke control and is a perfect choice for custom fabricating and short run production where complicated electronic control systems are not necessary. Production controls, die & die clamp options, backgauge, and custom speeds, tonnages, and colors also available. Proudly produced in the USA & CANADA!
74" Opening Width, 12" Open Height, 3.75" Stroke
10" Die Table with Adjustable Rails holds many types of toolingl
Hydro Mechanical Action
Tonnage Variable from 70 Tons top of stroke to 100 Tons on bottom end
Hydraulic Stroke Control with Gauge (electric stroke/cycle control available)
Cantilever Adjustment
All replaceable bushings and wear parts
Single or Three phase (your choice)
26 strokes per Minute with 5Hp (other pumps and speeds available)
Accepts Standard American Tooling (one die set included - call for options)
